SAXS

Small Angle X-ray Scattering Initiative for Europe :: Forum
It is currently 2018.05.23 22:39

All times are UTC + 2 hours




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: 2018.05.08 02:15 
Offline
Guest

Joined: 2018.05.08 02:03
Posts: 1
Hey there,
I am trying to get together multiple DAMs in order to get an average of what my particle might look like. I am using Scatter to analyze my data, however it is unable to open and run DAMMIN by itself. I am however able to run DAMMIN through the terminal (I am using MacOS 10.13.2), however I am only able to do one run at a time, so doing multiple iterations will be time/labor intensive. I am hoping someone might be able to provide some trouble shooting as to why Scatter is unable to run Dammin by itself, and/or how I might be able to use the terminal to do ten or more consecutive runs with Dammin. Any advice would be appreciated. Thanks.


Top
 Profile  
 
PostPosted: 2018.05.08 12:26 
Offline
Member

Joined: 2017.05.27 10:34
Posts: 5
Hi a2west,

You can run dammin multiple times, with a for loop inside the terminal. If you check the dammif manual you can see the syntax for bash:

$ for i in `seq 1 10` ; do dammif --prefix=lyz-$i --mode=slow lyz.out; done

https://www.embl-hamburg.de/biosaxs/manuals/dammif.html

Best regards
nassos


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC + 2 hours


Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
cron
Powered by phpBB® Forum Software © phpBB Group